Install the governor cover, gasket, and four retaining bolts.

May 15, Looking to buy/rent the bushing removal tool (Snap on # S). Anyone have any leads on getting this tool or any other way of removing the bushing. Note this trans uses the large bushing (just under 2 inch in diameter same one used on later Muncie and Turbo Estimated Reading Time: 1 min.

Jan 07, Here we see the sun gear shaft bushings, another high wear area that must always be replaced. The forward drum bushing replacement. The tool pictured in the middle and right was helpful in getting it in place without marring the bushing or drum.

A flat file was used to remove any burs to ensure proper sealing of the pump stumpclearing.barted Reading Time: 8 mins. This item: Streetside Tools SST - GM,R Extension Housing Bushing Driver/Installer and Removal Transmission Tool/KitOnly 19 left in stock - order soon/5(12).

Step 7: Replace Bushings. Remove and install new bushings into each end of the intermediate shaft, and install it into the transmission until it is fully engaged with the sun gear. It may help to turn the output and input shaft during installation to get the intermediate shaft to fully seat into stumpclearing.barted Reading Time: 9 mins.

Remove the apply piston retaining ring, springs, spring carrier, and apply piston from the center support.

Sep 15, Sep 13, Messages. 1, Oct 28, #9. Re: Removal Tool For Worcester tree removal Rod Bushing. I think the idea of the tap is to create about 3 threads (5/16") and then thread a 5/16" bolt into it.

At this point you can just pull on the bolt or tap it out from the underside with a Estimated Reading Time: 7 mins.