Figure 3: Removing the Pin.

Screw a 1/4” bolt extractor (see pictures below) counterclockwise with a pulling motion. The reducer will back out of Repeat for the other side. To remove the reducer piece from the bolt extractor, gently clamp it in a soft jawed vise only firmly enough to allow you to remove the bolt extractor with a clockwise twist. TIP: Do not over-tighten the vise, to avoid crushing the reducer piece. Figure 5: Freeing the Bolt Extractor from the Reducer Piece.

Step 1. Use a standard bolt extractor (EZ-Out or similar) to remove the two reducer pieces. Press the bolt extractor into either reducer with a counter-clockwise twisting motion, then pull while continuing to twist counter-clockwise to remove. Repeat for the second reducer. Aug 17, Use the rag to keep the pliers' jaws from mucking up the reducer. Spin the reducer out as you would with the bolt extractor. You can also put a good few layers of duct or electrical tape on the pliers' jaws to keep from chewing up the reducers.

5) For most applications you can order the reducers from Fox stumpclearing.barted Reading Time: 6 mins. To remove the reducer piece from the bolt extractor, gently clamp it in a soft jawed vise only firmly enough to allow you to remove the bolt extractor with a clockwise twist.

Do not over-tighten the vise, to avoid crushing the reducer piece. To remove the reducer piece from the bolt extractor, gently clamp it in a soft jawed vise only firmly enough to allow you to remove the bolt extractor with a clockwise twist.

Tip: Do not over-tighten the vise, to did george bush cut taxes crushing the reducer piece. Removing a worn nylon flanged bushing: You can use a small flat headed screw driver carefully lever the nylon bush out from the eyelet OR, use a small punch to drive them out from the centre.

Hold the shock steady and use caution to avoid slipping with the tool and damaging the shock's damper body.